ODROID-SHOW2

The ODROID-SHOW is the Arduino compatible that lets you see what your ODROID or PC is thinking using a small 2.2” TFT LCD.

You can show colorful texts and pictures via USB interface with VT100/ANSI style commands without big HDMI monitor. You can connect this tiny display to your ODROID as well as Mac, Linux PC, Windows PC even an enterprise server.

The form factor is designed for stacking on the ODROID-U3 and it comes with some PCB spacers and a USB cable.

There are I2C, ADC, GPIO pins for further expansion. We will introduce an add-on board with some sensor chips.

You can make it portable device with on-board charger by adding a 750mAh Li-Po battery. Because of very low power consumption, this is very useful for Wearable projects.

WiKi : https://wiki.odroid.com/accessory/display/odroid-show/odroid-show

 

 

BOARD DETAIL

 

PACKAGE INCLUDES

– ODROID-Show2 Board with 2.2inch TFT LCD Module
– 4 x 20mm PCB spacer (Plastic)
– 4 x 11mm PCB spacer (Metal)
– 4 x 10mm PCB spacer (Plastic)
– 1 x USB2.0 Type A to Micro-size Type B Cable

We highly recommend you to purchase 750mAh Battery together to make it portable.

 

 

SPECIFICATION

MCU	ATmega328P at 16Mhz
LCD	2.2inch 240 x 320 TFT-LCD(SPI 8Mhz interface)
Host Interface	USB to UART via on-board CP2104
Input Voltage	3.7 ~ 5.5 Volt
Power Consumption	60mA @ 5Volt
Serial Port Settings	baud rate : 500,000 bps(0.5Mbps) Stop bits : 8-N-1 No H/W, S/W Flow Control
MCU/LCD Voltage	3.45 V from CP2104 on-chip voltage regulator

 

 

HOW TO USE IT