Peel the protective backing off both sides of all the laser-cut pieces.

Add the spacers(G) with screws(I) on the piece (D).

Add the spacer(H) with screw(I) on the piece (D).

Check the right point again.

Alight the above part with ODROID-C2 or ODROID-C1+ which is 3.5inch Touchscreen Shield mounted.

Assemble the piece(E).

Assemble the piece(A).

Assemble the piece(C).

Please take more special care for the process from here. You might damage the acrylic piece.

Hang the top side of the piece(F) first. The round curve is the bottom side.

Assemble the bottom side of the piece(F) gently.

Please check the disassemble guide below.

Hang the top side of the pice(B) first. The round curve is the bottom side.

Assemble the bottom side of the piece(B) gently.

Please check the disassemble guide below.

Hold the locking part as picture beside.

Lift the bottom part from the locking just for 1-2mm

Caution!!
If you lift it up more, it might damage the locking part.

Release it from the locking.